I have quite a few Dragonlock collections and find them very good in general, but the stone bridge in this one is a disappointment compared to the usual quality. As if it was haphazardly thrown together at last moment by a summer intern.
The connection by peg is crappy and does not hold the bridge together. Especially since the peg is more than half mm thinner than the hole for the peg, so it will be loose in it. Also, the peg holes in the middle piece of the bridge are not of same length, which causes the peg to be a mm or so too long on one side of the peg, causing a gap.
Third, the middle piece underside is flat, so it doesn't fit with the ends of the bridge, that have nice textured undersides. Sure, the underside of the bridge is usually not seen, but still. It's a minor detail, but I don't see any reason why it can't have texture on both sides - Imo this piece could easily be printed on one of the sides with the peg hole instead of flat bottom (the peg hole is small enough so bridging should not be any problem at the point where the hole ends).
|